Seeker Dual radar
The remote
Press F5 for the remote. It works like the real unit's.
Buttons
| Button | Does |
|---|---|
| LOCK / REL | Locks or releases a speed on the active antenna. Plays the lock tone and calls out the antenna and whether the target is closing or moving away. FAST freezes the locked speed; TARGET keeps reading live |
| ANT | Switches the transmitting antenna, front ↔ rear. Only one transmits at a time, like the real unit. Also turns XMIT on |
| XMIT | Transmit on or off. The antenna has to be transmitting to see anything |
| MOV STA | Cycles Moving → Stationary Closing → Stationary Away → Bi-Directional |
| SAME / OPP | Lane mode for the current antenna: Off → Same → Opposite → Both |
| FAST LOCK | Turns the FAST window on or off. This is not a speed lock; use LOCK / REL |
| SEN | Detection range: 100 → 200 → 300 → 400 → 500 |
| PS | Lowest patrol speed that shows in the patrol window |
| TEST | Runs the self-test (about 6 seconds, ends in PASS) |
| VOL | Volume: 25% → 50% → 75% → 100% |
| BLANK | Blanks patrol speed while a lock is held |
LOCK / REL works whether FAST LOCK is on or off. With it on, the lock grabs a faster second vehicle if there's one in the beam; with it off, it locks the TARGET speed.
Display brightness isn't on the remote: it's in /seeker_settings.
Stationary modes
| Mode | Shows | Reads |
|---|---|---|
| Moving | [] | Normal patrol: targets while you drive |
| Stationary Closing | SC | Only traffic coming towards you |
| Stationary Away | SA | Only traffic moving away |
| Bi-Directional | S_ | Traffic either way |
The three stationary modes need the patrol car parked and never show a patrol speed. A car pacing you has no clear direction, so SC and SA skip it; S_ still reads it.
The display
| Window | Shows |
|---|---|
| TARGET | The main vehicle in the beam, always live |
| FAST | The fastest vehicle in the beam, if it's faster than TARGET. Holds the frozen speed on lock |
| PATROL | Your own speed |
Arrows. Each speed window has its own pair. Down: the car is closing on you. Up: it's moving away. Neither: it's pacing you. They show how that car is moving, not which antenna saw it; the FRONT and REAR icons tell you that.
Doppler audio
The tone tracks how far the target is above your own speed, not the number on the display:
| Situation | Tone |
|---|---|
| Parked, target doing 75 | High |
| Doing 65, target doing 75 | Low: only 10 over you |
| Target pacing you, or you're faster | Flat |
So slowing down raises the pitch on its own. The tone always follows TARGET, never FAST.
/toggledoppler cycles On → On (Stationary Only) (cuts out as soon as you roll) → Off. It starts off.
Stuck? Ask on Discord
View as Markdown